Routine inspection of the kaolin surface modification system prevents inconsistent modification degree, powder agglomeration, free coupling agent residue, cross‑contamination and safety hazards. It covers the modifier feeding system, mixing reactor, temperature & shear control, finished powder sampling, cleaning status and safety components. This inspection procedure fits the dry surface modification process widely introduced on kaolin‑mill.com.
1. Pre‑run visual and hardware inspection
Before starting the modification unit, inspect all mechanical and feeding parts.
Check the modifier storage tank and feeding hopper for sedimentation, caking, stratification or contamination. Confirm no water ingress into the modifier tank, since titanate and silane coupling agents react with moisture and lose activity. Verify the feeding pipeline, peristaltic pump or screw feeder for blockage, leakage and air bubbles. Check filter screens at the modifier inlet to remove solid impurities.
Inspect the mixing reactor sealing, gaskets, feed inlet and discharge chute. Loose seals allow humid air in, which causes uneven surface treatment. Also check all grounding cables for static protection, as organic modifiers carry fire risks.
2. Online parameter inspection during operation
Record and compare running parameters against the saved PLC recipe every shift.
- Temperature: Monitor reactor jacket temperature and material outlet temperature. Too low temperature leads to insufficient reaction between kaolin hydroxyl groups and coupling agents; overheating causes modifier decomposition, smoking and sticky agglomerates.
- Feeding rate: Cross‑check the kaolin powder feed rate and modifier addition ratio. The actual dosage must match the design loading; deviation is the main cause of under‑modification or over‑modification.
- Mixing speed and shear: Check agitator or high‑speed mixer current and rotation speed. Abnormal current may indicate material caking inside the chamber.
- Venting and exhaust: Check exhaust duct pressure and dust collector differential pressure. Poor exhaust accumulates modifier vapours and sticky deposits.
3. Intermediate sampling and quick performance tests
Take grab samples from the modified kaolin outlet at fixed intervals (e.g. every 30–60 minutes).
First, run a simple dispersion test: add modified kaolin into target resin or solvent, observe floating, wetting and agglomerate formation. Poor wetting means under‑modification.
Second, check flowability and caking tendency. Sift the powder and watch for sticky clusters. Sticky powder usually signals excess free coupling agent.
For periodic lab testing, test contact angle, oil absorption, surface energy and sedimentation behaviour. These indicators directly reflect modification quality. If batches drift out of the specification range, adjust modifier dosage or reaction temperature immediately.
4. Post‑run cleaning and residue inspection
After batch production, empty the reactor completely and inspect the inner wall, agitator blades and baffles. Sticky modifier‑kaolin deposits will carbonize or crosslink if left for long, and fall into subsequent batches to create speckles and unstable rheology.
Clean only with compatible solvents approved for the coupling agent type. Do not mix silane and titanate residues together. Confirm the discharge chute and transfer pipeline are free of sticky buildup before switching to another kaolin grade.
5. Safety and auxiliary component inspection
Inspect explosion‑proof electrical parts, temperature sensors, thermal interlocks and nitrogen inerting system (if equipped). Check the vapour exhaust filter for adsorbed modifier condensate.
Review alarm logs from the PLC system: alarms for high temperature, pump overload or feeding interruption must be recorded and resolved before the next production run.
6. Inspection frequency and record management
- Shift inspection: feeding pump, temperature, static grounding, visual powder appearance, exhaust status.
- Daily inspection: reactor internal residue, seal condition, filter pressure.
- Weekly inspection: full calibration of modifier metering pump, temperature probes and online weighing sensors.
- Monthly inspection: complete disassembly check of mixing blades, wear parts and vent lines.
All inspection data, sample test results and abnormal handling records should be kept for batch traceability.
The target of routine inspection is not only to check whether equipment works, but to guarantee stable interfacial performance. Even if all hardware runs normally, slight drift of modifier proportion or reaction temperature can make modified kaolin fail in plastic, coating or masterbatch applications.