High-gradient magnetic separation (HGMS) is a key purification technology for kaolin. It removes iron-bearing impurities that reduce kaolin whiteness, such as hematite, goethite, magnetite and iron-stained silicate minerals. Based on kaolin processing technology from kaolin-mill.com, HGMS is widely used in wet kaolin purification lines to produce high-brightness coating and filler-grade kaolin.
Basic working principle
Ordinary low-intensity magnetic separators can only capture strongly magnetic minerals like magnetite. Most iron impurities in kaolin are weakly magnetic, so they require high magnetic field gradient.
HGMS uses a strong external magnetic field combined with a matrix of fine ferromagnetic steel wool or expanded metal. The matrix creates extremely localized, high-gradient magnetic fields around the steel filaments. When aqueous kaolin slurry flows through the matrix:
- Weakly magnetic iron-containing particles experience magnetic attractive force.
- The magnetic force pulls iron impurities onto the surface of the steel matrix.
- Non‑magnetic pure kaolin particles pass through the matrix and flow out as purified slurry.
- After saturation, the magnetic field is switched off. The matrix is flushed with high-pressure water to wash away trapped iron impurities, ready for the next cycle.
Typical process flow
- Slurry preparation: Crude kaolin is dispersed into water with dispersants to form low-viscosity slurry. Agglomerated iron-bearing micro-particles are fully liberated from kaolin platelets.
- Pre‑treatment screening: Remove coarse sand and large mineral aggregates to avoid blocking the HGMS matrix.
- Magnetic separation: The dilute kaolin slurry flows through the magnetized matrix inside the HGMS chamber. Weakly magnetic iron contaminants are captured.
- Rinse and discharge: Cut off the magnetic field; backwash the matrix to discharge iron-rich tailings.
- Post processing: Purified kaolin slurry goes through filtration, drying and milling to obtain high-whiteness kaolin powder.
Key influencing factors
- Magnetic field intensity: Higher field strength improves capture of ultra-fine weakly magnetic iron oxides, but increases energy consumption.
- Slurry flow rate: Slow flow gives longer residence time and better iron removal, yet reduces throughput.
- Slurry concentration: Too high solid content raises particle collision and blocking risk; low concentration benefits separation efficiency.
- Particle liberation: Iron must be fully separated from kaolin platelets via wet grinding and dispersion. If iron is locked inside kaolin crystals, HGMS cannot remove it.
- pH value: Adjusting slurry pH changes surface charge of iron impurities, affecting adsorption onto the magnetic matrix.
Advantages of HGMS for kaolin
- Effective for ultra-fine, weakly magnetic iron contaminants that gravity separation or low-intensity magnets cannot remove.
- Continuous wet operation, matching the wet kaolin purification route for papermaking and coating grade kaolin.
- No chemical additives, so it does not change kaolin’s crystal structure.
- Greatly improves whiteness and reduces iron oxide content, which is critical for high-end applications.
Limitations
- It only removes magnetic iron-bearing minerals. Non‑magnetic iron impurities (such as iron trapped in crystal lattice or non-magnetic iron silicates) cannot be separated by HGMS.
- The steel matrix is easy to clog if slurry contains coarse particles or poor dispersion.
- Higher capital and energy cost compared with gravity beneficiation.
High-gradient magnetic separation removes iron impurities from kaolin by generating localized high magnetic gradients on a ferromagnetic matrix. Weakly magnetic iron oxide particles are captured from the flowing kaolin slurry while non‑magnetic kaolin platelets pass through. This technology is an indispensable wet purification step for high‑whiteness kaolin production. It works best when iron minerals are fully liberated from kaolin crystals, with controlled slurry concentration and flow rate. HGMS is normally combined with classification and bleaching to achieve ultra-low iron content for premium kaolin products.